ATOMRC Exceed 500mW MINI

This is the AtomRC exceed 500mw mini VTX, A 20x20mm VTX board, designed to run on any size of quadcopter, where you have the need for a reliable video signal.

ATOMRC Exceed VTX Manual

Channel/BAND/Power setting

• Hold the button 3s to switch the Channel/Band/Power mode, the RED LED will show the mode.
• In Channel setting mode, press the button to change the channel, the channel will cycle as 1、2、3、4、5、6、7、8、1… , blue led will show the channel status.
• In Band setting mode, press the button to change the band, the band will cycle as A、B、E、Airwave、Race、L Band、A… , blue led will show the channel status.
• It will take 200ms delay to save the setting.
• No button operation for 5 seconds, VTX will quit setting mode.

Wiring

The  ATOMRC Exceed VTX has a  bridge pad near the connector to select input voltage, by default the input voltage is set to 5V, we recommend you keep the bridge in place unless you have a  particular need to change this.

The TX pad on the bottom is IRC tramp telemetry pads, connect this pad to FC TX. You will be able to change channel and band using smart audio function via the transmitter. Reliable power level changes should be made using the physical button on the VTX board.

The 5V out solder pad should be only be used to provide power to a camera, take care you do not send a input voltage via this pad, it will damage the board.

More Information

ATOMRC VTX Table

Download this file, open it in notepad, Save it, rename it with a (DOT)JSON file extension.

You can then use the “From File” function. In Betaflight  ——-VTX, to pull in the file contents.