Flywoo ExpressLRS 2.4G Receiver (EL23E / EL24P )

This is the Flywoo ExpressLRS 2.4G receivers series. You can choose from two variations. The ELRS EL24E (ceramic antenna) and the ELRS EL24P ( UFL T antenna )

The Flywoo 2.4GHz ELRS Nano Series Receiver is an Open Source Program Based on Expresslrs, the Lightweight, the Lightweight, Minimal Size, Use ESP8285 MCU. So You Can Upgrade Firmware by WiFi, That’s Too Simple, divided into two Version EL24E / EL24P.

• EL24E: ESP8285 MCU, SX1280 RF CHIP, it has a Built-in Ceramic Antenna, Which Is Super Light and Small in Size.
• EL24P: ESP8285 MCU, SX1280 RF CHIP, use IPX ports, connect external T-type antennas, farther distance, stronger signal

Due to the low-latency and high-refresh-rate rf module, They is the Ultra Light and Nano size of the Ultra Light and Nano Size.

Product Information

EL24E Nano Receiver

• Type: ISM
• ESP8285 MCU
• SX1280IMLTRT RF Module
• SMD Ceramic antenna
• Frequency Range: 2400 MHz to 2500 MHz
• Maximum receive refresh rate: 500Hz
• Minimum receiver refresh rate: 25Hz
• Working voltage: 5v
• Weight: 0.4g
• Dimension: 10.8mm*11mm*6mm
• Peak gain: 3.7dB

EL24P Nano Receiver

• Type: ISM
• ESP8285 MCU
• SX1280IMLTRT RF Module
• Frequency Range: 2400 MHz to 2500 MHz
• Maximum receive refresh rate: 500Hz
• Minimum receiver refresh rate: 25Hz
• Working voltage: 5v
• Weight: 0.4g
• Dimension: 10.8mm*11mm*6mm
• Peak gain: 3.2dB
• 1 PCS 40mm half – wave dipole antenna

In the box

1 x Flywoo ELRS receiver of your choosing.

More Information

Currently the EL24E/EL24P are sold with pre-loaded firmware the Official versions. You can upgrade the official firmware as official firmware is updated.

Please visit here for up to date information and firmware download.

Bind procedure:

• Supply power to the EL24E/EL24P rx, wait until the LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the RX is powered on for the third time, the LED light will start to double-flash, which means that the RX enters the binding mode
• Insert the 2.4G ELRS TX to Radio transmitter, and choose External RF mode to CRSF protocol, then you can find ELRS menu from the Radio systems(Need to copy the ELRS.LUA file to the SD-Card tools first), Enter into ELRS and press [Bind], the LED on the RX module will getting to be solid if bind successfully.
• Receiver LED status meanings:

EL24E/EL24P RX: LED turns solid it means binding is  successful or Connection established, Double flashing LED’s means it’s in bind mode; LED’s flashing slowly means no signal connection from the TX module; When the LED’s flash fast it  means it’s in WIFI hotspot mode, you can connect the WIFI of the RX and upgrade firmware of the RX via visit 10.0.0.1 from the web browser(password: expresslrs)