SpeedyBee F7 Flight Controller V3 (30×30)
This is the SpeedyBee F7 Flight Controller V3.
The correct replacement F7 Flight Controller for the Speedybee F7 V3 30×30 Flight Stack.
The head turning feature of this ESC, is it’s wireless connectivity , which allowed you access to your setup and logs wherever you are.
|SpeedyBee F7 V3 Flight Controller
|USB Port Type
|Supported. Used for Flight Controller configuration
|Flash FC Firmware Wirelessly
|Supported. Please enter MENU > FC Firmware Flasher
|Supported. Please enter MENU > Blackbox Analyzer
|DJI Air Unit Connection Way
|Two ways supported: 6-pin connector or direct soldering.
|BetaFlight Camera Control Pad
|Yes(CC pad on the front side)
|3S – 6S Lipo
|10 groups of 5V output, three +5V pads and 1 BZ+ pad( used for Buzzer) on front side, and 6 +5V output included in the connectors on bottom side. The total current load is 2A.
|2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 4A.
|Supported. Designed for 3.3V-input receivers. Up to 500mA current load.
|Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load.
|ESC Signal Pads
|M1 – M4 on bottom side and M5-M8 on front side.
|5 sets(UART1, UART2, UART3, UART4(For ESC Telemetry), UART6)
|ESC Telemetry UART
|Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc.
|Used for WS2812 LED controlled by Betaflight firmware.
|BZ+ and BZ- pad used for 5V Buzzer
|Supported. Named as RS on the front side.
|Use any TX pad of UART for the SmartPort feature.
|Supported Flight Controller Firmware
|BetaFlight(Default), EMUFlight, INAV
|Firmware Target Name
|30.5 x 30.5mm( 4mm hole diameter)
|41(L) x 38(W) x 8.1(H)mm
In the box
1 x SpeedyBee F7 V3 30 x 30 Flight Controller