SpeedyBee F745 35A BLS AIO Flight Controller (25.5 x 25.5)
This is the SpeedyBee F745 35A BLS AIO flight controller.
This is a high quality AIO board that can be used to build your next light weight FPV drone.
The SpeedyBee F745 is best suited for those frames that have the 25.5x 25.5 mounting holes and are large enough to accommodate the slightly larger board.
A crucial difference between this board and those like it. is it’s clever offboard setup and configuration options.
The Speedybee 35A AIO is supplied with an external USB-C connector, that’s temporarily soldered on by the user and easily removed once the initial changes have been saved.
Flight controller USB connectors can limit how and where you mount yours, in this instance you are encouraged to use the Wifi phone/tablet app to make the necessary changes to Betaflight and BLHeli_S firmware.
Please be mindful of this boards dimensions as they may not be suitable for frames where space is at a premium.
- Wifi (2.4 )and Bluetooth, enables AIO FC
- High quality and fast F745 MCU
- Durable 35A ESC using Toshiba MOSFETs
- Onboard DJI connector port.
- 4 UARTS, Baro, I2C, 8MB Blackbox
|SpeedyBee F745 35A BLS AIO
|3S – 6S Lipo
|25.5 x 25.5mm, 3mm hole diameter
|36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5″ or above
|Need to solder a USB TYPE-C module to D+,D-,GND pads.
|Supported. Used for parameter configuration
|Flash FC Firmware Wirelessly
|DJI Air Unit 6-pin Connector
|BetaFlight Camera Control Pad
|4 groups of 5V output. The total current load is 2.5A.
|Supported. Up to 500mA current load.
|ESC Signal Pads
|M1 – M4
|Full UART * 4(UART1, UART2, UART3,UART4)
|ESC Telemetry UART
|Used for WS2812 LED
|BZ+ and BZ- pad used for 5V Buzzer
|Used to enter DFU mode
|Use any TX pad of UART for the Smart Port feature.
|Supported Flight Controller
|Firmware Target Name
|35A * 4